U++ framework: TopWindow&PopUp, TrayIcon » Simple way of switching dialogs

Home » U++ Library support » TopWindow&PopUp, TrayIcon » Simple way of switching dialogs

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Simple way of switching dialogs [message #28540]

Mon, 06 September 2010 12:34

cbpporter
Messages: 1428
Registered: September 2007

Ultimate Contributor

What is the simplest way to close your current window and replace it with another window. Basically, swap out the "main" window of your application.

Right now I have to Close and Hide current window, call Run on new window and after new window gets closed, call Show and Run on old window. I couldn't get the desired behavior while using other methods from TopWindow.

Report message to a moderator

Re: Simple way of switching dialogs [message #28548 is a reply to message #28540]

Mon, 06 September 2010 15:51

koldo
Messages: 3461
Registered: August 2008

Senior Veteran

Hello cbpporter

In this case I have some StaticRects for a TopWindow.

To go from one page to other, I hide all StaticRects but the one I want to see.

For example I use this in a setup wizard program.

Perhaps this is not the fanciest way but it is simple and gui behavior is right. When I closed and opened windows, the gui behavior was not the best Smile

Best regards
Iñaki

Report message to a moderator

Re: Simple way of switching dialogs [message #28549 is a reply to message #28548]

Mon, 06 September 2010 16:02

dolik.rce
Messages: 1796
Registered: August 2008
Location: Czech Republic

Ultimate Contributor

Hi guys,

koldo wrote on Mon, 06 September 2010 15:51

In this case I have some StaticRects for a TopWindow.

To go from one page to other, I hide all StaticRects but the one I want to see.

For example I use this in a setup wizard program.

I used the same approach for setup wizard... I am just not sure if StaticRect is the best choice, ParentCtrl is IMHO much better suited for this purpose. The downsize of this approach is that it assumes all the windows have same size - or you have to resize it properly on each switch.

Honza

Report message to a moderator

Previous Topic:	Howto set the icon for the application/and or topwindow in the code?
Next Topic:	New Theme caption problem.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Sep 14 23:59:45 GMT+2 2026

Total time taken to generate the page: 0.00812 seconds