U++ framework: Newbie corner » HowTo bind StaticImage to SQL

Home » Community » Newbie corner » HowTo bind StaticImage to SQL

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: HowTo bind StaticImage to SQL [message #43638 is a reply to message #43630]

Wed, 17 September 2014 08:09

koldo
Messages: 3460
Registered: August 2008

Senior Veteran

Hello Jerson

A problem about this is that it is not clear the behavior of SetData(). Should it save the image file name, or the image itself?

In fact, there are already two versions of StaticImage::Set(), one for file name and other for Image data.

A possible solution would be to add a method to indicate what will be the Set() behavior.

Best regards
Iñaki

Report message to a moderator

[Message index]

		HowTo bind StaticImage to SQL By: jerson on Sat, 13 September 2014 06:32
		Re: HowTo bind StaticImage to SQL By: Didier on Sat, 13 September 2014 22:26
		Re: HowTo bind StaticImage to SQL By: jerson on Sun, 14 September 2014 05:16
		Re: HowTo bind StaticImage to SQL By: jerson on Mon, 15 September 2014 07:58
		Re: HowTo bind StaticImage to SQL By: koldo on Tue, 16 September 2014 09:46
		Re: HowTo bind StaticImage to SQL By: jerson on Tue, 16 September 2014 10:25
		Re: HowTo bind StaticImage to SQL By: koldo on Wed, 17 September 2014 08:09
		Re: HowTo bind StaticImage to SQL By: jerson on Wed, 17 September 2014 12:32
		Re: HowTo bind StaticImage to SQL By: koldo on Thu, 18 September 2014 08:40

Previous Topic:	StaticImage cannot show BMP file
Next Topic:	>Port 9(say port 10)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Jul 06 04:19:35 GMT+2 2026

Total time taken to generate the page: 0.00518 seconds